Operation Manual – 802.1x and System Guard
H3C S3100-52P Ethernet switch
Chapter 1 802.1x Configuration
1-21
To do...
Use the command...
Remarks
quit
Note:
z
The proxy checking function needs the cooperation of H3C's 802.1x client (iNode)
program.
z
The proxy checking function depends on the online user handshaking function. To
enable the proxy detecting function, you need to enable the online user
handshaking function first.
z
The configuration listed in the above table takes effect only when it is performed on
CAMS as well as on the switch. In addition, the client version checking function
needs to be enabled on the switch too (by using the
dot1x version-check
command).
1.4.2 Configuring Client Version Checking
Follow these steps to configure client version checking:
To do...
Use the command...
Remarks
Enter system view
system-view
—
In
system
view
dot1x version-check
[
interface interface-list
]
interface
interface-type
interface-number
dot1x version-check
Enable
802.1x
client
version
checking
In port
view
quit
Required
By default, 802.1x client
version checking is disabled
on a port.
Set the maximum
number of retires to
send version
checking request
packets
dot1x retry-version-max
max-retry-version-value
Optional
By default, the maximum
number of retires to send
version checking request
packets is 3.
Set the client version
checking period timer
dot1x
timer ver-period
ver-period-value
Optional
By default, the timer is set to
30 seconds.
