Command Manual – VLAN-VPN
H3C S3100-52P Ethernet Switch
Chapter 2 Selective QinQ Configuration Commands
2-1
Chapter 2 Selective QinQ Configuration
Commands
Note:
The selective QinQ feature is new to H3C S3100-52P Ethernet Switch.
2.1 Selective QinQ Configuration Commands
2.1.1 mac-address-mapping
Syntax
mac-address-mapping
index
source-vlan
source-vlan-list
destination-vlan
dest-vlan-id
undo mac-address-mapping
{
index
|
all
}
View
Ethernet port view
Parameters
index
: Index of the inter-VLAN MAC address replicating configuration to be created or
removed. This argument is in the range 0 to 7.
source-vlan source-vlan-list
: Specifies a list of the IDs of the VLANs, whose MAC
address entries are to be replicated to the MAC address table of the destination VLAN.
You need to provide the
source-vlan-list
argument in the form of {
vlan-id
[
to
vlan-id
] }&<1-10>, where the VLAN ID after the
to
keyword must be larger than or
equal to the VLAN ID before the
to
keyword and &<1-10> means that you can specify
up to 10 VLANs/VLAN ranges for this argument.
dest-vlan-id
: ID of the destination VLAN for replication, in the range 1 to 4094.
all
: Removes all the inter-VLAN MAC address replicating configurations created on the
current port.
Description
Use the
mac-address-mapping
command to configure the inter-VLAN MAC address
replicating feature for a port. This feature can replicate MAC address entries of the