58
Step Command Remarks
for the device.
max-selected-port
max-selected-port-number
and an aggregation group can have a
maximum of 16 Selected ports.
Displaying and maintaining Ethernet link
aggregation
Execute
display
commands in any view and
reset
commands in user view.
Task Command
Display information for an aggregate interface
or multiple aggregate interfaces.
display interface
[ {
bridge-aggregation
|
route-aggregation
} [
interface-number
] ] [
brief
[
description
|
down
] ]
Display the local system ID.
display lacp system-id
Display the link aggregation capability for the
device.
display link-aggregation capability
Display the global or group-specific
link-aggregation load sharing modes.
display link-aggregation load-sharing mode
[
interface
[ {
bridge-aggregation
|
route-aggregation
}
interface-number
] ]
Display forwarding information for the specified
traffic flow.
display link-aggregation load-sharing path interface
{
bridge-aggregation
|
route-aggregation
}
interface-number
ingress-port
interface-type
interface-number
[
route
] { {
destination-ip
ip-address
|
destination-ipv6
ipv6-address
} | {
source-ip
ip-address
|
source-ipv6
ipv6-address
} |
destination-mac
mac-address
|
destination-port
port-id
|
ethernet-type
type-number
|
ip-protocol
protocol-id
|
source-mac
mac-address
|
source-port
port-id
|
vlan
vlan-id
} *
Display detailed link aggregation information
for link aggregation member ports.
display link-aggregation member-port
[
interface-list
]
Display summary information about all
aggregation groups.
display link-aggregation summary
Display detailed information about the
specified aggregation groups.
display link-aggregation
verbose
[ {
bridge-aggregation
|
route-aggregation
}
[
interface-number
] ]
Clear LACP statistics for the specified link
aggregation member ports.
reset lacp statistics
[
interface
interface-list
]
Clear statistics for the specified aggregate
interfaces.
reset counters interface
[ {
bridge-aggregation
|
route-aggregation
} [
interface-number
] ]
Ethernet link aggregation configuration examples
Layer 2 static aggregation configuration example
Network requirements
On the network shown in
, perform the following tasks:
•
Configure a Layer 2 static aggregation group on both Device A and Device B.
