3-8
Figure 3-5 Installing a cable management bracket (S12516R)
(1) Spring tab on the cable management bracket
(2) Align the cable management bracket with the bracket hole
NOTE:
You must press the spring tab while removing a cable management bracket.
Installing fabric modules
CAUTION:
•
Before you install a fabric module on the device, make sure the connectors on the fabric module
are not damaged or blocked.
•
When you install a fabric module, avoid damaging the connectors on it.
•
Install fabric modules or fabric module slot filler panels before you install the fan tray.
•
Install filler panels in the empty fabric module slots.
•
To replace or install a fabric module for an operating device, first remove the fan tray that covers
the slot of the fabric module. Install the fan tray immediately after the replacement or installation.
After the fan tray starts operating, you can replace or install fabric modules whose slots are
covered by the other fan tray.
•
The smart speed adjustment feature increases the fan speed when only one fan tray is operating.
Take noise protection measures such as wearing an earmuff or earplug. In addition, make good
preparation before hot swapping a fabric module to minimize the operation time.
CAUTION:
To prevent card damage and ensure correct operation, fabric modules can only be used with service
modules of the same type. Type H fabric modules have a character string of
SFH
in their card
identifier (for example, LSXM1
SFH
16CR1). Type H service modules have a character of
H
in their
card identifier (for example, LSXM1CGQ36
H
BR1).
