5
Figure 2 Power module installation procedure
To install the power module:
1.
Wear an ESD wrist strap, and make sure the strap makes good
skin contact and is reliably grounded.
2.
Unpack the power module. Make sure the power module model
is as required.
3.
As shown in
, correctly orient the power module.
Holding the power module handle with one hand and supporting
the power module bottom with the other, align the power module
with the target power module slot. Push the power module
slowly into the slot along the guide rails until the latch clicks and
locks in place.
Make sure the power module makes good contact with the
backplane connector of the device.
If you encounter a hard resistance while inserting the power
module, pull out the power module, orient it correctly, and then
insert it again.
