6
5.
Use a Phillips screwdriver to fasten the captive screws on the power
module to secure it in the chassis. See callout 2 in
If the captive screw cannot be tightly fastened, examine the
installation of the power module.
Figure 5 Installing the power module
Removing the power module
1.
Wear an ESD wrist strap, and make sure the wrist strap makes good
skin contact and is reliably grounded.
2.
Disconnect the power cord from the power module and the external
power supply.
3.
Face the power module to be removed from the powered device.
4.
Use a Phillips screwdriver to loosen the captive screws on the power
module until the captive screws are disengaged from the powered
device.
5.
Grasping the handle of the power module with one hand, pull it part
way out. Then supporting the power module bottom with the other
hand, pull the power module slowly out of the slot along the guide
rails.
6.
Put the removed power module into an antistatic bag.
