H3C MSR810, Command Reference Manual

Page: 61 / 389

49
Default
Both the username and the descriptor are used for MP binding on an interface.
Views
VT interface view
Dialer interface view
Predefined user roles
network-admin
Parameters
authentication
: Uses the username for MP binding.
both
: Uses both the username and the endpoint descriptor for MP binding.
descriptor
: Uses the endpoint descriptor for MP binding.
Usage guidelines
The username is obtained from the peer during PAP, CHAP, MS-CHAP, or MS-CHAP-V2
authentication. The endpoint descriptor, which uniquely identifies a device, is obtained from the peer
during LCP negotiation. Based on the username or endpoint descriptor, the system can locate the
corresponding VT interface and create an MP bundle according to the template.
The
descriptor
mode cannot differentiate users. To bind users to different bundles, use the
both
mode.
The
authentication
mode cannot differentiate peer devices. When multiple peer devices exist, use
the
both
mode.
Examples
# Specify Virtual-Template 1 to use the username for MP binding.
<Sysname> system-view
[Sysname] interface virtual-template1
[Sysname-Virtual-Template1] ppp mp binding-mode authentication
ppp mp endpoint
Use
ppp mp endpoint
to set the endpoint option.
Use
undo ppp mp endpoint
to restore the default.
Syntax
ppp mp endpoint endpoint
undo ppp mp endpoint
Default
The endpoint option carries the device name on an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
endpoint
: Specifies the content of the endpoint option, a case-sensitive string of 1 to 20 characters.