14
Installing a SIC interface module
CAUTION:
SIC interface modules are not hot swappable. Make sure the device is powered off before installing
a SIC.
To install a SIC:
1.
Use a Phillips screwdriver to remove the fastening screws on the filler panel and remove the
filler panel.
2.
Push the SIC slowly into the slot along the guide rails until it makes close contact with the
backplane.
3.
Fasten the captive screws on the SIC.
Figure 11 Installing a SIC
Connecting interface cables
Connect cables to the interfaces on the device before powering on the device.
Connecting an Ethernet copper port
1.
Connect one end of the cable to the Ethernet port on the device. Connect the other end of the
cable to the Ethernet port on the peer device.
The fixed ports on the device are MDI/MDIX autosensing. You can use straight-through or
crossover network cables to connect the ports.
2.
Examine the port LED on the device. For more information about the LEDs, see "Appendix B
LEDs."
