2-25
Figure2-25 Removing the filler panel
4.
Orient the power supply with the upside up. Grasp the handle of the power supply with one
hand and support its bottom with the other, and slide the power supply slowly along the guide
rails into the slot.
To prevent damage to the power supply and the connector on the switch backplane, insert the
power supply gently. If you encounter a hard resistance or the power supply tilts while inserting
the power supply, pull out the power supply, realign it with the slot, and then insert it again.
Figure2-26 Installing a power supply
Removing a power supply
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Power off the power supply and remove the power cord.
3.
Press the latch towards the handle, and pull the power supply along the guide rails until it is
part-way out.
4.
Grasp the handle of the power supply with one hand and pull the module part way out. Support
the module bottom with the other hand, and pull the power supply slowly along the guide rails
out of the slot.