2
Table 17 Login parameters
Login parameter
Data
Serial Line to connect to
COMn, where
n
indicates the serial port number.
The value is an integer. The specific value is
subject to the actual settings.
Speed (baud)
9600 (default)
Data bits
8 (default)
Stop bits
1 (default)
Parity
None (default)
Flow control
None (default)
The data marked "default" are configured before factory delivery. The actual data during on-site
operations shall prevail.
2.
After login, the CLI of the switch module displays the login page, as shown below.
********************************************************************************
* Copyright (c) 2004-2019 New H3C Technologies Co., Ltd. All rights reserved. *
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
********************************************************************************
<Sysname>
Logging in to the SOL serial port through redirection
Prerequisites
•
The switch module has been powered on. For details, see "Powering on the switch module
•
You have logged in to the CLI of the OM module. For details, see "Logging in to the CLI of the
OM module."
Configuration procedure
On the OM CLI, run the
sol connect
command to log in to the CLI of the switch module in slot 1.
<OM>sol connect io 1
Begin to edit commands.
<Sysname>%Jul 29 13:42:35:975 2013 H3C SHELL/5/SHELL_LOGIN: Console logged in from c
on1.
<Sysname>
Note
After logging in to the CLI of the switch module through the SOL serial port in redirection mode, enter "~" and "."
(the entered "~" is not displayed on the CLI) in any view. Press
Enter
to log out and go back to the OM CLI.
