Important Seal Information
Button Pad Control
Play / Pause Button
Next / Fast -
Forward Button
Previous / Rewind
Button
Volume up
Volume down
The Interval Waterproof Headphone System features a removable silicone seal that forms
a waterproof barrier between the base and lid of the case. It is extremely important that
special attention is paid to ensure the silicone seal is completely seated in the groove of
the lid. If the seal is loose, out of alignment, twisted or pinched in any way, it will
compromise the waterproof integrity of the case and should not be used. Any debris
such as hair or sand will keep it from forming a watertight barrier and should be cleaned
off before use.
Caution:
If the seal comes out of alignment, carefully place it in the groove, ensuring all 4
corners are correctly installed. Compress the lid to the base and then re-open it to make
sure the seal is fitted correctly into the groove. The seal should appear straight and uniform
along its’ edge and should not fall out easily.
If you have any concerns please contact H2O Audio Customer Support.
Installing the shuffle into the case
Open Case
Close Case
Ensure the case is
closed and locked.
Plug audio jack into the shuffle player, place shuffle into case and ensure the
control pad and the Button Pad Control are aligned. Close case.
1
2
3
4
5
6
The H2O Audio Interval Waterproof Headphone System is a swim specific music solution
for the iPod shuffle (2
nd
Gen). The integrated waterproof case easily attaches to practically
any swim goggle providing a low profile, tangle free listening experience.
Before using your Interval Waterproof Headphone System for the first time, it is highly
recommended that you become familiar with opening and closing the case to ensure the
case is sealed properly during use. To verify that you have sealed the case properly we
recommend that you test the product without a shuffle inside before initial use. Please
follow the instructions below.
Getting Familiar with Your Headphone System
1. Open the case and verify the seal area is clean and free of debris or damage.
2. Submerge the system in water and soak for 30 min.
3. Manipulate the Button Control Pad during submersion.
4. Remove from water and dry exterior.
5. Open the housing and ensure there is no water inside the case.
If water is found inside the case please contact H2O Audio Customer Support immediately.
Introduction
Copyright Notice:
This owner’s manual is copyrighted, all rights reserved. It may not, in whole or in part, be copied,
photocopied, reproduced, translated, or formed into any electronic format without prior consent in
writing. H2O Audio is a registered trademark of H2O Audio, Inc. Apple and iPod are registered
trademarks of Apple Inc.
Before using this system, please be sure to read, understand, and follow the instruction of this manual.
Waterproof Headphone System
Developed for Swimming
h2oaudio.com
iSH3-70 20081013
