EN
23
User manual
GYSPRESS PREMIUM 10T PUSH-PULL
Translation of the original
instructions
RIVET EXTRACTION
For car body repairs, old or damaged rivets must be removed from the metal sheets. To avoid the necessity of
removing these rivets by drilling, the extraction tip and its die should be used. They allow the rivets to be removed
without damaging the sheet metal.
Before using the riveter, and to facilitate the extraction of self-piercing
rivets, an indentation can be made on the rivet with a Centre Punch
Tool (048379) so that the extraction punch can subsequently be
wedged into the recess.
If the rivet remains in the die hole during extraction, remove it before
performing another extraction.
Once the hole is punched, release the pressure immediately. Bringing
the point to the end of its travel can generate additional stresses on the
point, which may cause it to break.
CONTROLS AND MAINTENANCE
The riveter does not require any special maintenance. A basic periodic visual check is recommended to prevent any breakdown or failure during
use.
Clean the riveter at least once a week to remove all dust and dirt that could affect the long-term performance of the product. Use self-cleaning clo
-
ths. Do not use any water, nor flammable or corrosive liquids.
During maintenance, the compressed air supply must be disconnected from the unit.
