GW Instek GRF-1300, User Manual

Page: 11 / 110

Introduction to the GRF-1300
Usage Instructions
1. For safety purposes, please connect the unit to the correct AC
power source: 100V~240V,
50-60Hz.
Make sure the ground terminal is properly earthed to prevent
electric shock.
2. The power socket and USB port are on the rear panel. The
power switch is on the upper
left-hand side of the device.
USB port
AC socket Power switch
Procedure
3. When using several modules together at the same time,
connect each module with the appropriate RF cable.
Figure A-3.
Connection
diagram between
different modules
4. The UP and DOWN buttons on the Baseband module can be
used to adjust the frequency of the baseband signal. The
baseband module is adjustable in 10kHz steps.
•
WAVE Select is used to select three different baseband
waveforms. When the waveform is selected, the
corresponding LED light will be lit up.
•
The Reset button is used to reset the GRF-1300. When reset,
the GRF-1300 will output a 0.10MHz sine wave baseband
signal and a carrier signal with a frequency 880MHz.
•
The output port is used to output the set baseband signal.
9