GV-395 Virtex-II DSP Hardware Accelerator Manual
GV & Associates, Inc.
07/10/04
46
14.0
GVA-395 Configuration Jumper Settings
The table below describes the various setup configuration for the GVA-395
JP5
JP6
JP9
JP10
Not
Installed
Not
Installed
Not
Installed
Install
Enables the configuration of the FPGAs via the JTAG Connector JP3.
Installed Not
Installed
Not
Installed
Installed Enables the configuration of the FPGAs via the Slave Serial Connector
JP7.
Installed Not
Installed
Installed Not
Installed
Enables the configuration of the FPGAs via the on-board FLASH
EEPROM.
Installed Installed Not
Installed
Installed Enables the configuration of the FPGAs via the Slave Serial Connector
JP7 and
program the on-board EEPROM
14.1.1
GVA-395 Jumper Configuration Table