14
INSTALLATION
Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be preserved
around the hole.
Be sure the thickness of the work surface is at least 30 mm. Please select heat-resistant
work surface material to avoid larger deformation caused by the heat radiation from
the hotplate. As shown below:
SEAL
Under any circumstances, make sure the Ceramic cooker hob is well ventilated and
the air inlet and outlet are not blocked. Ensure the ceramic cooker hob is in good work
state. As shown below
Note:
The safety distance between the hotplate and the cupboard above the
hotplate should be at least 650 mm.