Select the User ID
1
.When the blood pressure monitor is off, press and hold “ ”button
until the user ID blinks. Then press “ ” button to change the user ID
between user 1 and user 2. Press “ ” button to confirm your selection.
Before you start the measurement, please select the desired user ID first.
2
. After confirming the user ID, the LCD will turn off. Then you can start
your measurement now.
Tie the Cuff
1.
2.
3.
4.
5.
Remove all accessories (watch, bracelet,etc) from your wrist. If your physician
has diagnosed you with poor circulation in your wrist, use the other one.
Roll or push up your sleeve to expose the skin.
Apply the cuff to your wrist with your palm facing up.
Position the edge of the cuff about 1cm~1.5cm from wrist joints.
Fasten the wrist cuff around your wrist, leaving no extra room between the
cuff and your skin. If the cuff is too loose, the measurement will not be
accurate.
Sit comfortably with your tested wrist resting on a flat surface. Place your
elbow on a table so that the cuff is at the same level as your heart. Turn your
palm upwards. Sit upright in a chair, and take 5-6 deep breaths.
Rest for 5 minutes before first measuring.
Wait at least 3 minutes between measurements. This allows your blood
circulation to recover.
The patient must relax as much as possible and do not move and talk during
the measurement procedure.
For a meaningful comparison, try to measure under similar conditions. For
example, take daily measurements at approximately the same time, on the
same wrist, or as directed by a physician.
Keep your back against the backrest of the chair.
6.
7.
Take the measurement in a silent room.
The cuff should maintain at the same level as the right atrium of the heart.
Please sit comfortably. Do not cross your legs and keep your feet flat on the
ground.
Helpful tips for patients, especially for patients with Hypertension:
13
12
MEASUREMENT
MEASUREMENT
