Installation
G&D DVIMUX4-PS/2 ·
4
Connecting the console devices
Keyb.:
Plug the connection cable of the PS/2 keyboard in this socket.
Mouse:
Plug the connection cable of the PS/2 mouse in this socket.
Speaker:
Connect the speakers to this interface for output of audio signals at the
active computer.
Monitor 1:
Plug the monitor’s DVI-I cable to this interface.
ADVICE:
Connect the cables of the console and the computers preferably block by
block and from the bottom up. By doing so, you will avoid already connected
cables blocking your view of the interfaces.
Figure 2: Interfaces to connect the console devices
NOTE:
You can also connect a USB keyboard and/or a USB mouse to the
USB K/M
interfaces on the front panel of the device.
The PS/2 interfaces (on the back panel of the KVM switch) as well as the USB
interfaces on the front panel of the device can be used for connecting both console
keyboard and console mouse.
NOTE:
If you purchased a multi-channel variant of the KVM switch, connect the
additional monitors to the
Monitor 2
(MC2, MC3 and MC4),
Monitor 3
(MC3 and
MC4) resp.
Monitor 4
(MC4) interfaces.
Power
Keyb.
Mouse
Line In
CPU 1
DVI-I CPU 1.1
Keyb.
Mouse
Line In
CPU 2
DVI-I CPU 2.1
Monitor 1
Keyb.
Mouse Speaker
CON
Keyb.
Mouse
Line In
CPU 3
DVI-I CPU 3.1
Keyb.
Mouse
Line In
CPU 4
DVI-I CPU 4.1
Summary of Contents for DVIMUX4-PS/2
Page 1: ...G D DVIMUX4 PS 2 Installation and Operation...
Page 37: ...Notes G D DVIMUX4 PS 2 34...
Page 38: ...Notes 35 G D DVIMUX4 PS 2...
Page 39: ...Notes G D DVIMUX4 PS 2 36...