Installation « Central Module
7
· G&D DVICenter DP64
Installing and connecting target modules
Connecting target computers to target modules
Connect the target computer to the different target modules.
This step is described in the paragraph
Target module
on page 31.
Connecting target modules to the central module
Connect the
Transmission
interfaces of the target modules to the
Dynamic Port
that is
configured for connecting a target module. In the default, these are ports 17 to 64.
Use a category 5e (or better) twisted-pair cabling for connecting the devices.
IMPORTANT:
You can place target modules up to 140 metres away from the central
module.
NOTE:
If required, enable the signalling in the
Dynamic Ports
modes (see page 17).
The
Dynamic Ports
for connecting the target modules are highlighted by green
LEDs.
IMPORTANT:
The
DVI-CPU-UC
target module provides two
Trans.
interfaces. Only
connect one
Trans.
interface of the target module (see page 37) to the matrix switch.
