Establishing a KVM-over-IP™ connection for the first time
G&D DP-Vision-IP ·
14
English
Configuring a KVM-over-IP connection
The
IP address
of the user module (host) as well as the
control port
of the computer
module must be specified to establish a
KVM-over-IP
connection through the com-
puter module.
The configuration of both the
communication ports
and the
data ports
are automatically
exchanged between the two modules.
How to configure a KVM-over-IP connection:
1. Use the remote hotkey
Ctrl
+
Num
to open the OSD of computer module.
2. Select the entry
KVM connection
and press
Enter
.
3. Enter the following data under
Network setting
:
4. Press
F2
to save your settings.
Configuring a KVM-over-IP connection of a user
module
You can carry out the required configuration settings directly on the console.
Configuring the network interface
How to configure the network interface:
1. Use the remote hotkey
Alt
+
Num
to open the OSD of user module.
2. Select the entry
Network setup
and press
Enter
.
3. Select the entry
Interfaces
and press
Enter
.
NOTE:
The configuration of both the
communication ports
and the
data ports
are
automatically exchanged between the two modules.
Control port:
Enter the number of the port you want to use.
Communication port:
Enter the number of the port you want to use.
Data port:
Enter the number of the port you want to use.
NOTE:
Use the
local hotkey
(default:
Alt
+
Num
) to open the local OSD to configure
the network interface of the user module
,
or use the
remote hotkey
(default:
Ctrl
+
Num
) to open the remote OSD to configure the network interface of the com-
puter module.
The settings of both hotkeys are shown during the starting process of the user
module (see
