27
.............................
CCEC/ OM Manual GlasStile GSS 1.6 EN
07
.2009
Section 6
Maintenance
Maintenance
General Care
The GlasStile GSS Entrance Gate should be cleaned and greased, where directed, at regular
intervals, using the following approved materials.
Routine Cleaning, all finishes
Cleaning agent.
Soap or mild detergent water.
Action:
Sponge rinse with clean water, wipe dry as necessary
Fingerprints
Cleaning agent:
Soap or warm water or organic solvent (acetone, alcohol, genciene)
Action:
Rinse with clean water and wipe if necessary
Stubborn Stains and Discoloration, all Finishes
Cleaning agent:
Mild cleaning solutions or domestic service cleaners.
Action:
Rinse well with clean water and wipe dry.
Oil, Grease Marks, all Finishes
Cleaning agent:
Organic solvents (acetone, alcohol genciene, trichlorethane)
Action:
Clean after with soap and water, rinse well with clean water and wipe
dry.
Rust and other Corrosion products, Stainless Finishes
Cleaning agent:
Oxalic acid. The cleaning solution should be applied with a swab and allowed
to stand for 15 to 20 minutes before being washed away with water. May
continue using a domestic surface cleaner to give final clean
Action:
Rinse well with clean water (precautions for acid cleaners should be
observed).
Minor Scratches on Painted Surfaces
Cleaning agent:
Lightly rub with cutting paste. Rinse area with water and dry.
Apply touch-up paint in fine layers.
Action:
Allow 2 weeks to harden. Blend into surrounding paintwork, using a fine
cutting paste.
Deep Scratches on Painted Finishes Causing Rust
Cleaning agent:
Remove rust with a small sharp knife. Apply rust inhibiting paint (red
oxide). Fill scratch with fine body filler to just under finished surface. Follow
procedure for minor scratches.
