C.1.
A.
Take the hanging bracket and secure it to the outlet box (marked acceptable for fan support) using
the mounting screws provided with the outlet box. See Fig 5. Tighten them evenly.
WARNING - To Reduce The Risk Of Fire, Electric Shock, Or Personal
Injury Mount Fan To An Outlet Box Marked "Acceptable For Fan
Support" And Use The Mounting Screws Provided With The Outlet Box.
2.
Page 3
Now tuck the wires and wirenuts carefully into outlet box. Make sure the Green and White wires are
tucked into one side of the box and the Black and Blue wires are tucked into the other side of the box.
Make sure wirenuts remain tightly on connections.
If you have a Gulf Coast Remote Control, fan should be wired according to method A.
Method B can be used with two separate controls for the fan and light, or with a combination wall control,
such as a 423L Gulf Coast control.
III. Hanging the fan motor...
Holding the fan carefully, lift it up to hanging bracket. Place the ball into
cradle of the bracket. Turn the entire motor assembly until it locks into
place. The tab on the bracket must be in the groove in the ball. Make
sure the wires are not being pinched. See Fig 6.
FIG. 6
Gulf Coast Fans 2010 - Portions
â
1993
Remove one canopy screw (also Fig 5) and loosen the other. Make
sure all of the wires are accessible and are not being pinched. Also,
make sure the bracket doesn't wobble.
FIG. 5
There are three common wiring methods; choose the one best suited to your needs. Keep in mind, the
supply wire colors may vary. (The wire colors in parentheses are commonly found in existing structures.)
Use the large orange wirenuts to make the connections. It is a good idea to wire the blue light kit wire
now, even if you don't have a light kit. It may save you some trouble in the future.
IV. Wiring methods and instructions.
A. Pull chain operation only.
1. Green ground wires to outlet box ground (bare)
2. Black and blue wires from fan to hot supply (black)
3. White wire from fan to neutral supply (white)
See Fig 7.
B.
Wall control for both fan and light kit (Read the
instructions for the wall control first.)
1. Green ground wires to outlet box ground. (bare)
2. Black wire from fan to (black) wire from fan control.
3. Blue wire from fan to (red) wire from light control.
4. White wire from fan to neutral supply. (white)
See Fig 8.
C. Pull chain operation of fan - Wall control for the light.
1. Green ground wires to outlet box ground. (bare)
2. Black wire from fan to hot supply. (black)
3. Blue wire from fan to (red) wire from wall control.
4. White wire from fan to neutral supply. (white)
See Fig 9.
FIG. 7
BLUE
FAN
BLK
WHT
SUPPLY HOT
SUPPLY NEUTRAL
FIG. 8
BLUE
FAN
BLK
WHT
FROM FAN CONTROL
FROM LIGHT CONTROL
SUPPLY NEUTRAL
SUPPLY HOT
FAN
LIGHT
GULF COAST
FIG. 9
BLUE
FAN
BLK
WHT
FROM SUPPLY HOT
FROM LIGHT CONTROL
SUPPLY NEUTRAL
SUPPLY HOT
ON
ON
