8
©
Guldmann 1642 - 05/2021 # 90068_101
©
Guldmann 1642 - 05/2021 # 90068_101
To extend the ramp
Hold the ramp by the handle in your right hand, and pull the ramp
out to its full length by gripping the contact surface of the inner
part of the ramp. Position as required. If the catch device should
be moving too tightly, it can be lubricated with oil or another lub-
ricant.
EasyFold ramps
Placement
Place the ramp corectly before usage, open the ramp after place-
ment. See pictures for correct placement.
Upper position:
Incorrect use
Correct use
Lower position:
Incorrect use
Correct use
When setting up EasyFold-Pro, the ramp should be positioned
such that the bent contact surface is supported. Then unfold the
upper ramp. EasyFold-Pro3 folds in folds in three parts, so it is
easier to store away. To unfold the ramp, pull the lock beside the
handle and unfold the ramp.
Telescopic EasyFold ramp
The ramp should be placed on a firm underlay.
The ramp should be positioned such that the entire bent contact
surface of the ramp is supported.
The ramp should be carried by the handles and the contact sur-
face positioned on the upper level. Then unfold the upper ramp.
The upper ramp closest to the body is extended to the desired
length and placed on the upper level. Afterwards the other half of
the upper ramp is extended. Always check that the ramp is placed
in a stable and safe way.
To prevent the suitcase ramps from sliding on underlays with low
friction, the safety pin should always be mounted before using the
ramps.
Important!
Do not start up electric wheelchairs which have stopped on the
ramp, as the various parts of the ramp may extend unintentionally
by so doing. In the event of a wheelchair stopping in the middle of
the ramp, reverse down and start from the bottom again.
1.05 Important/Warnings
• Read all the operating instructions before using the ramp.
• Do not exceed the load marked on the ramp.
• The ramp should only be used for driving wheelchairs up and
down.
• Wheelchairs should be driven up and down at low speed
- without a run-up.
• The ramp should be positioned such that the entire contact
surface is supported.
• The ramp should be used on a firm underlay.
• The ramp should not be used for gradients greater than 1:5
- for electric wheelchairs or wheelchairs pushed by a helper.
• The ramp should not be used for gradients greater than 1:7
- independent user of manual wheelchair.
• Watch out not to squeeze fingers when closing the ramp.
• The handle on EasyFold-Pro can not be changed if it breaks off,
it will only break off if it is not placed back in place after use.
• Do not kick ore push the ramp in place
• If damage is suspected, the ramp must not be used before the
dealer has authorized it.
• Any serious incident that occurred in relation to this device
should be reported to the manufacturer and the local compe-
tent authority.
• To avoid breakage, the ramp should be carried by the
handle(s).
• Do not modify this equipment without the authorization of the
manufacturer.
1.06 Unpacking and Preparation of the Ramp
Visual Check of the Ramp
If the packaging is damaged on receipt, the ramp should be
inspected carefully for visible deficiencies, defects or faults.
If damage is suspected, the ramp must not be used before
qualified service personnel or the Guldmann Service Team have
authorised it.
2.00 Labels and Marking
CE marking
Medical Device Class I in accordance
with EU MDR Regulation
Read the manual before use
Caution