12
Make sure the batteries are charged. See
section
Power
Power below.
Open the battery compartment and insert
the batteries.
Press the ON/OFF button to start the Easy
Locator Core.
Note!
When powering OFF; press and hold
the ON/OFF button.
The batteries are found under the black lid. It
is possible to hot-swap, one battery at time,
during measurements.
The ON/OFF button will blink to indicate start/boot. When the light turns steady, the Easy
Locator Core is ready to be connected to the MALÅ Controller App.
Note!
If the light is blinking very fast, this indicates a problem with the unit. Please
contact the Guideline Geo support team for further assistance.
Start measurements
Make sure MALÅ Controller App is
installed on your mobile device.
MALÅ Controller App can be downloaded from
https://www.guidelinegeo.com/product/mala-controller-app/
or by using the QR code.
Set up a mobile hotspot for communication
between your mobile device and the Easy
Locator Core. The Easy Locator Core serial
number is found on the label on the back-
right corner.
For hotspot, change the network name
(SSID) to
MALAxxxxxxxx
, where
xxxxxxxx
refers to the serial number and change
the password for the mobile hotspot to
mala0123
For further instructions see;
MALÅ
Controller App User Manual
or
MALÅ
Controller App Quick Guide
.
Label with information on serial number
and QR code.
Summary of Contents for MALA
Page 1: ...MAL Easy Locator Core User Manual...
Page 5: ...5...
