l
43
Manual Power Control
Note:
The Dashboard needs to be In command mode to make any changes.
Manual Power Control can be used to switch off the normal automatic power control for
the rotor on the CyScan Sensor and to apply and adjust a fixed constant power instead.
To Enable Manual Power Control:
1. Click on the
Tracking
button on the side bar.
2. Click on the
Reflections
tab, if not already in focus.
3. Click on the
Manual Control
tick box, in the
Power Control
panel.
To Use Manual Power Control:
1. Adjust the power level by clicking on the left or right hand side of the control until the
required value is displayed.
2. Click on the
Apply
button to confirm the changes.
To Disable Manual Power Control:
Click on the
Manual Control
tick box and on the
Apply
button to confirm.
The tick box will clear and the Power Level control will be removed.
Summary of Contents for CyScan AS
Page 62: ......