GUDEL ZP 3-5 V4, Operating Manual

Page: 104 / 354

Tool Use Item number
Corrosion protection
agent MOTOREX In-
tact XD 20 Installing the coupling
Applying corrosion
protection to the
product
0502037
Table 7-14 Special tools, testing and measuring instruments
Install the motor and coupling as follows:
Prerequisite:The gearbox unit is installed on the adjacent construction
Ü 2
184
Prerequisite:The gearbox flange has been aligned correctly
Ü 2
95
Prerequisite:The input shaft has been aligned correctly to the gearbox
flange
Ü 2
97
Prerequisite:The couping has been positioned correctly on the motor
shaft
Ü 2
99
1 Switch off the plant and padlock it to prevent it from being switched on
again
2 Attach slings to the motor if necessary
Ü 2
178
3 Clean the coupling, input shaft and wedge to remove any grease
4 Installing the wedge on the input shaft
5 Apply corrosion protection agent to the wedge and input shaft with a
brush
6 Push the motor, with the mounted coupling, onto the gearbox unit
7 Install and tighten motor screws
8 If the motor screws cannot be fitted:
8.1 Ventilate the motor brake if necessary
8.2 Turning the motor into correct installation position
8.3 Repeat process from step 7
9 Tighten the coupling screws:
9.1 Tighten alternately to 50% of the tightening torque TA
9.2 Tighten alternately with 100% of the tightening torque TA
10 Mount plug
The motor and the coupling have been installed.
Commissioning OPERATING MANUAL ZP 3-5 V4
72057594174110603_v5.0_
EN-US
104