GUDEL FlexxPump4 B, Operating Manual

Page: 58 / 157

6.4.2 Basics
Average lubricant
requirement at a
lubrication point
(U)
The following lubricant quantities should be dispensed at least per lubrication
point. These are empirical values from Güdel. These values can be met only
approximatively due to the number of outputs of the lubricant pump and the
installed splitters.
Size Average lubricant requirement per lubrication point
(U)
1-4 0.3 cm
3
/ 100 km
5-7 0.4 cm
3
/ 100 km
Tab. 6-1 Average lubricant requirement per lubrication point (U)
Recommended lu-
brication quantity
(P
t
)
The recommended lubrication quantity P
t
can be found in the following table.
System Size 1-4 Size 5-7
3 lubrication points (e.g. EP,
TMF, TMO) 0.9 cm
3
/ 100 km 1.2 cm
3
/ 100 km
6 lubrication points (e.g. ZP) 1.8 cm
3
/ 100 km 2.4 cm
3
/ 100 km
9 lubrication points (e.g. CP,
ZP H-loader) 2.7 cm
3
/ 100 km 3.6 cm
3
/ 100 km
10 lubrication points (e.g. FP) 3.0 cm
3
/ 100 km 4.0 cm
3
/ 100 km
Tab. 6-2 Recommended lubrication quantity (P
t
)
6.4.3 Minimum lubrication quantity
Splitters only function correctly if > 0.5 cm
3
of lubricant is produced at their
input per lubrication cycle.
Operation OPERATING MANUAL FlexxPump4 B lubrication system
3421295627_v1.0_
EN-US
58