GUDEL CP 3-5 V2, Operating Manual

Page: 147 / 350

Lubrication ex
works Specification Lubrication quantity
Ü
Chapter 9.2.2.1,
2
134
Ü
Chapter 9.2.2.1,
2
134
Roller size 10-20: 4.5
cm³
Roller size 25-52: 7.5
cm³
Roller size 72-215: 12
cm³
Table 9-14 Lubricants: Guideways, racks, and pinions
Lubricate the guideways, racks, and pinions as follows:
Prerequisite:There is no automatic lubrication
1 Switch off the system and padlock it to secure it against being switched
on again
2 Press in the lubricant into the grease nipple using a grease gun
2.1 for all available wiper and lubrication units or roller supports: Lu-
brication quantity
2.2 for all available lubricating pinions: Double lubrication quantity
The guideways, racks and pinions are lubricated.
9.3.8 Maintenance tasks after 2,250 hours
9.3.8.1 General inspection
Performing a gen-
eral inspection
For the general inspection, perform a rough check of the entire product.
Perform the general inspection as follows:
1 Switch off the system and padlock it to secure it against being switched
on again
2 Check the inspection points as described in the inspection table
3 Take measures as described in the inspection table
The general inspection is complete.
Maintenance OPERATING MANUAL CP 3-5 V2
9007202252815371_v1.0_
EN-US
147