Malfunction
Cause
Measure
Lubrication system does not lubricate
The measured counterpressure was too high three times
in a row. Hydraulic connections or hoses may be
blocked, hoses too long, and/or lubricant too stiff/hard.
Pump function has been stopped.
Remove cause of the counterpressure, switch off the power supply to the
FlexxPump and switch it on again. The fault is set to zero. The FlexxPump
starts up again.
Lubrication system does not lubricate
Various causes
• Switch off the power supply to the FlexxPump and switch it on again. This
does not delete the data memory.
• Contact the service department if the problem reoccurs
Table 5-3
Malfunctions / Troubleshooting
Commissioning
OPERATING MANUAL Automatic lubrication system
FlexxPump 404DLS
99079191943154059_v10.0_
EN-US
54
