Gude Expert Power Control 1100, Manual

Page: 12 / 23

12
Expert Power Control 1100/1101 Configuration
4.3.5 Configuration - HTTP
4.3.5.1 HTTP Port
Here you can enter the HTTP port number, if necessary. Possible numbers are 1 ... 65534 (standard: 80). To get access to
Expert Power Control 1100/1101, you have to enter the port number behind the IP address of Expert Power Control
1100/1101, e.g.: http://192.168.0.2:1720
All changes need a restart of the firmware to get valid.
4.3.5.2 Enable HTML Auto Refresh
You can activate and de-activate the auto-refresh of the web interface. The auto-refresh keeps the information of the status
page up to date, but the additional network traffic can be unwanted.
4.3.5.3 Require HTTP Password
Password protected access can be activated here. In this case, a user and an admin password have to be defined.
Passwords have a maximum lengths of 15 characters.
Administrators are authorized to switch all ports and to modify the settings of Expert Power Control 1100/1101 and of all
ports. The username of the admin is “admin”.
Users are authorized to switch all ports but are not allowed to modify the settings of neither Expert Power Control
1100/1101 nor the ports. The username of the user is “user”.
If you have forgotten your password, activate the bootloader mode of Expert Power Control 1100/1101, start GBL-Conf.exe
and deactivate the password request.
All changes need a restart of the firmware to get valid.
4.3.5.4 Check Password on start page
If activated, the user has to enter his password, before logging in to the webinterface.