Gude Expert Power Control 1100, Manual

Page: 10 / 23

10
Expert Power Control 1100/1101 Configuration
4.3.3 Configuration - IP Address
4.3.3.1 Hostname
Enter the host name of Expert Power Control 1100/1101. Expert Power Control 1100/1101 uses this name to connect with
DHCP server.
Special signs may destabilize your network.
All changes need a restart of the firmware to get valid.
4.3.3.2 IP Address
Here you can change the IP address of Expert Power Control 1100/1101.
All changes need a restart of the firmware to get valid.
4.3.3.3 Netmask
Here you can change the netmask of Expert Power Control 1100/1101.
All changes need a restart of the firmware to get valid.
4.3.3.4 Gateway
Here you can change the standard gateway of Expert Power Control 1100/1101.
All changes need a restart of the firmware to get valid.
4.3.3.5 Use DHCP
Here you can set, if Expert Power Control 1100/1101 shall get its TCP/IP settings directly from your DHCP server. If DHCP
is activated, Expert Power Control 1100/1101 proves if a DHCP server is active inside of your LAN. Then Expert Power
Control 1100/1101 requests TCP/IP settings from this server. If there is no DHCP server inside of your network, we
recommend to deactivate this function.
All changes need a restart of the firmware to get valid.