Introduction
Please read thoroughly this operation manual and
attached safety instructions to enjoy your new electric
garden waste shredder. We further recommend to retain
the operation manual for future references. We reserve
right to make technical changes for the purpose of
improvement in the course of continuous product
development.
This is the original operation manual.
Scope of supply
Unpack the appliance and check completeness and
delivery of the following components:
•
GH 2600 P or GH 2600
•
filling hopper
•
pusher
•
collection bag or box
•
original user guide
Please contact your seller if you either miss some
components or the components are damaged.
If assembled, weight of the appliance is 23.5 and 28 kg,
respectively. If needed, two persons may lift the appliance
from the packing.
Description of the appliance
Sturdy and quiet shredder with rolling technology and
reverse operation feature. Ideal for cutting of branches and
bushes; the garden waste is processed in fine chips by
simultaneous cutting by blades and roll crushing for faster
composting. Automatic drawing of crushed material up to
40 mm in diameter in, direct drive and undervoltage
switch.
GH 2600 P #94062 (Fig. A)
1. filling
hopper
2.
overload safety feature
3.
Start pushbutton (green), Stop pushbutton (red)
next to it
4.
forward and reverse operation pushbutton
4A.
forward operation feature
4B.
reverse operation feature
5. plug
6. ventilation
holes
7. carriage
8. collection
bag
9.
set screw for crushed material size control (Fig.
H/13)
10. ejection
shaft
GH 2600 P #94064 (Fig. E)
1.
overload safety feature
2.
Start pushbutton (green), Stop pushbutton (red)
next to it
3.
forward and reverse operation pushbutton
3A.
forward operation feature
3B.
reverse operation feature
4. filling
hopper
5. plug
6.
set screw for crushed material size control (Fig.
H/13)
7. collection
box
8.
side holder of the collection box
9. leg
10. transport
wheels
11.
collection box clamping lever (Attention! the
appliance does not start without clamping.)
Technical data
ELECTRIC GARDEN WASTE SHREDDER GH 2600 P
#94062
Voltage/frequency:
230V~50Hz
Engine power:
2600W (P1;S6 40%)**
Engine max. revolutions:
2994
min
-1
Protection type:
IPX4
Max. branch diameter:
max. 40mm
Collection bag volume:
50l
Noise level:
L
WA
88dB *
Dimensions LxWxH (in mm):
600x470x930
Weight:
23.5kg
ELECTRIC GARDEN WASTE SHREDDER GH 2600
#94064
Voltage/frequency:
230V~50Hz
Engine power:
2600W (P1;S6 40%)**
Engine max. revolutions:
2994
min
-1
Protection type:
IPX4
Max. branch diameter:
max. 40mm
Collection bag volume:
60l
Noise level:
L
WA
86dB *
Dimensions LxWxH (in mm):
640x485x860
Weight:
28kg
*
Noise information
Noise values were measured according to 2000/14/EC
(1.60m height, 1m distance) - measurement tol-
3dB
**
Operation mode S6 40% indicates load profile: 40 seconds
load and 60 seconds idle operation, long-term operation is
acceptable for normal operation.
General safety instructions
Read this user guide thoroughly. Make sure you know the
controls and correct use of the appliance. Store the user
guide safely for future reference.
Safe work
Keep your workplace tidy!
Disorder on workplace may result in injuries.
Consider surrounding conditions!
Do not expose to rain.
Do not use in moist or wet environment.
Provide good lighting.
Do not use close to flammable liquids or gases
Keep other persons in a safe distance!
Other persons, particularly children, may not touch the
device and power cable. Keep them in a sufficient distance
from your workplace.
Store your device properly!
The device, if not used, should be stored in a dry and
closed space, out of reach of children.
Do not overload your device!
Operate the appliance within specified working capacity.
Use correct device!
Do not use the device for purposes other than intended.
Take care of your appliance!
Observe maintenance directions and instructions.
Check appliance cable regularly and ask an authorized
specialist to replace the same if damaged.
16
