Cleaning
•
Keep the protective equipment, ventilation slots and
engine covers with no dust and dirt if possible. Wipe
the appliance with a dry cloth or blow it with
compressed air at low pressure.
•
The appliance is recommended to be cleaned
immediately after being used.
•
Clean the appliance regularly with a wet cloth and a
bit of soft soap. Do not use any cleaners and solvents
as they could damage the plastic parts of the
appliance. Make sure no water gets in the inside of
the appliance.
Carbon brushes
Have the carbon brushes checked by an electrician when
sparks are produced excessively.
Caution!
Carbon brushes may only be replaced by an
electrician.
Servicing
There are no other parts inside the appliance requiring
servicing.
Transport
The appliance must cool down before being transported.
Troubleshooting
The table shows possible failures, their causes and
remedy options. If the problem still cannot be removed,
contact a professional to help you.
Switch the appliance off and unplug it before any
servicing and cleaning.
Risk of electric shock.
Troubleshooting table
Symptoms
Possible cause
Remedy
Saw blade is
broken
•
Saw blade is too thin for
the processed material
•
Too much pressure on the
saw blade
•
Saw blade is too
stretched
•
Curve cut is too narrow
•
Fit a thicker saw
blade
•
Move the
workpiece
continuously with
even, however,
not too much
pressure on the
saw blade. Let
the saw work by
itself.
•
Reduce the saw
blade tension
•
Bigger radius or
narrower saw
blade
Saw blade is
not cutting
straight, it is
turned
•
Saw blade is too loose
•
Saw blade has been
subject to too intensive
side loading
•
Saw blade getting
warm/workpiece is too
thick.
•
Increase the saw
blade tension
•
Replace the saw
blade
•
Use a straight
saw or thinner
material
Engine
slowing
down and
remaining
standing
•
Saw has been overloaded
by the workpiece
•
Saw blade is worn out
•
Chippings have blocked
the exhaust flue
•
Opt for higher
revolutions; do
not apply too
much pressure
on the saw blade
•
Replace the saw
blade
•
Remove any
chippings from
the cover.
Connect the
exhaust
equipment or
increase the
exhaust
equipment output
Dust
accumulatin
g in the
appliance
•
Produced as a result of
standard work
•
Clean the
appliance at
regular intervals
Laser or
LED lamp
not working
•
Laser or LED lamp are
defective
•
Replace the laser
or LED lamp
15