FACTORY RE-SETTING AND
POWER CYCLING
YOUR GUARDZILLA CAMERA
______________________________________________________________
Guardzilla 180 Indoor
This guide describes how to:
1)
F
actory reset your camera; and 2) Power cycle your camera.
Power cycling
your camera will retain all your settings. It’s a good first step if you are experiencing issues
with your camera. A
factory reset
of your camera will remove all of your camera’s settings and will require
you to set up your camera all over again.
______________________________________________________________
FACTORY RE-SETTING YOUR CAMERA
1
Make sure that your camera is plugged in.
.
2
Locate the RESET button on the back of your camera.
.
3
Press the RESET button and hold it down. Wait a few seconds for the LED light on the top of the
camera to blink red and blue, then release the button. Your camera will now go through the factory
reset process. When it finishes re-setting the LED will start blinking green. The camera can now be
added back onto your network (see Step 4 below), if desired.
