6
Door Test
Before beginning installation of the operator please complete the following test to insure that your door is balanced and
in good working condition. A poorly balanced door could cause severe personal injury and damage to the opener.
Always have a qualified garage door service person make any needed adjustments and/or repairs to your door before
proceeding with installation.
1. Raise and lower the door and check closely for areas of
sticking and binding. Check for loose hinges, wobbly
rollers, frayed cables and damaged or broken springs.
Contact a qualified garage door service person to make
the necessary adjustments.
2. Lift the door approximately halfway. When released, the
door should stay in that position. If door pulls open or
moves downward, the spring mechanism is not
adjusted properly. Contact a qualified garage door
service person to make the necessary adjustments.
3. When properly installed and adjusted the door will
remain clear of the opening, when allowed to rest at its
natural full open position. If door drifts up or down the
door is not adjusted properly. Contact a qualified
garage door service person to make the necessary
adjustments.
Do Not Install the Opener Until These
Adjustments and Repairs Have Been Made.
Carefully follow the instructions for the assembly and
installation of the garage door opener contained in this
manual
Tools Required for Assembly and Installation
Sectional Door
One Piece Door w/ Track
!
Claw Hammer
5mm and
8mm Drill Bit
Step Ladder
Hand Saw
Screw Driver
Drill
Tape
Measure
Pencil
Pliers
Open
End
Wrench
8mm
13mm and
11mm Socket
and Wrench
Level
