Guardian Telecom
VoIP Telephones
Setup & Configuration
Page 10
7.
Getting Started
The Installation manual for the telephone provides information on installing and connecting the device to the server.
This manual describes the steps required to customize the telephone to suit the individual's preferences.
The Discovery Utility is available on Guardian’s website at
https://www.guardiantelecom.com/resources/voip-support/
needs to be installed manually by copying the executable file to a local drive.
To access a VoIP phone for programming:
•
Install the Guardian Discovery Utility onto the network server or SIP server.
•
Start the Utility by double clicking the icon.
•
Click on “Refresh List".
•
Click on the device to be programmed to highlight it.
•
Click on “Launch Browser".
Figure 2 - Startup Screen
8.
RESET Switch
The RESET switch is used to get the IP address of the device or to reset to factory defaults.
•
To get the IP address of the device press and release the RESET switch within a
5
second window and it will
speak the IP address through the handset earpiece.
•
To reset to factory defaults press and hold the RESET switch for more than 10 seconds until it indicates that it is
restoring defaults and rebooting the board.
9.
Configure the Telephone Parameters
To configure the Telephone online use a standard web browser.
All Telephones are initially configured with the following default IP settings:
Parameter
Factory Default Setting
IP Addressing
DHCP
IP Address
a
10.10.10.10
Web Access Username
admin
Web Access Password
admin
Subnet Mask
a
255.0.0.0
Default Gateway
a
10.0.0.1
Table 1 - Factory Default Settings
a. Default if there is not a DHCP server present.
When configuring more than one Telephone attach the Telephones to the network and configure one at a time to avoid IP
address conflicts.