29
11.2013 | G28314 | Printed in Germany
13 Help in case of malfunctions
Installers or end-users must not repair a faulty motor themselves. Professional repair can only
be carried out by the manufacturer. If you open the motor or manipulate it in any way, the war-
ranty shall be null and void.
º
Therefore you should replace a faulty motor and have it repaired.
º
If the motor stops, check whether the limit position switch is activated.
In case any problems arise during installation or operation of the drive, please consult the fol-
lowing table for possible help:
Problem
Possible cause
Solution
Drive not
functioning
•
Mains adapter without current sup-
ply.
•
Connecting cable unplugged or
wire(s) loose.
•
Mains adapter not providing the
rated voltage (24 V).
•
Switching mains adapter in the drive
damaged, not providing low voltage.
º
Protection switch or
safety switch.
º
Check all electrical con-
nection of drive.
º
Exchange mains adapter.
º
Exchange drive.
LED lit but the drive
not working
•
Drive damaged as a result of over-
voltage or other destruction
º
Exchange drive
Limit stop not
functioning
•
Programming not carried out cor-
rectly.
•
Failure of the electrical DIP switch
contact.
º
Repeat programming of
DIP switch.
º
Exchange drive.
* The blue LED is located in the opening of the housing together with the DIP switches
If the motor does not respond to actuation by switch/button, have the power supply checked by
a qualified person.
14 Dismantling and disposal
Dismantling
DANGER
Observe the safety instructions of installing!
For dismantling the appliance proceed as described under chapter „8 Installation (mechanical)“
on page 32, however, in reverse order. Settings are irrelevant.
Disposal
Note!
º
Motor components
•
Aluminium
•
Iron
•
Plastic
•
Copper
•
Zinc
º
Dispose of the parts in accordance with the local disposal regulations.
