GTS BG 132, Installation And Operating Manual

Page: 90 / 128

Sy
nch
ro
no
us g
en
er
at
or
s o
f s
er
ie
s D
G
G
, D
W
G a
nd W
G
Issue 05/2013 Page 90
Operation
Generator operation
Note
y Equipment powered by electric motors may need start-up
currents which can be many factors higher than the indicated
operating currents.
►
In case of doubt, please get in touch with the manufacturer.
>
Every work day carry out a check on the insulation monitor to ensure it is
suitable for work. (where available)
Ö
Check insulation monitor, page 91(where available)
>
No devices are allowed to be connected to the power generation system.
>
Switch off all devices to be connected (device switch to position “OFF”
or “0”. Risk of accident caused by devices started up in an uncontrolled
fashion!
>
Start the drive unit.
>
Wait until the drive unit has reached its nominal speed.
>
Switch on the protective circuit breaker depending on the model in the
attached switch box or in the switch box (position “ON” or “1”).
Ö
Switch box Fig. 6, Switch box with installed options operating hours
counter and insulation monitor, page 24
Ö
Switch cabinet Fig. 5, Terminal box with terminal board, generator
controller and noise filter, page 22
>
Switch on the main switch on the switch cabinet. (Position “ON” or “I”).
>
When wanting to connect devices of protection class I (devices with
protective earth and non protective insulated metal housing parts), carry
out the protective earth check for these devices every work day.
>
Connect the devices up and switch them on in sequence. Switch on the
powerful units with high current consumption or high starting current first
then the less powerful units.
Switch off the connected devices
>
Switch off the units in sequence. (where possible, first switch off the units
with the lower performance followed by the more powerful devices).
>
Disconnect the power-supply plug of the units.
>
Close all hinged covers correctly.