GTS BG 132, Installation And Operating Manual

Page: 49 / 128

Page 49 Issue 05/2013
Installation of generator
Installation of single-bearing generators
1
4x 2
Install a appropriate seal
for the drive motor
Fig. 13 Assembly of single-bearing brush generators with tension bolts
6.6.5.2 Assembly of brushless generators
Ö
Fig. 14, Assembly of brushless single-bearing generators with
tension bolts (1), page 50,
Ö
Fig. 15, Assembly of brushless single-bearing generators with
tension bolts (2), page 51
>
Perform preparatory disassembly.
>
Remove the carbon brush holder (s).
Ö
Preparatory disassembly, page 45
The steps described here replace the steps in the assembly section.
Shaft attachment assembly via grub screw, page 42
>
Install a appropriate seal on the front bearing plate of the generator.
Ö
Generator seal to the drive motor, page 40
>
Remove the front bearing plate, place a seal on it, and place it onto the
flange of the drive motor and secure with four screws [2] .