GTS BG 132, Installation And Operating Manual

Page: 35 / 128

Page 35 Issue 05/2013
Installation of generator
Holes for condensation water discharge
6.5 Holes for condensation water discharge
The drain holes for condensation water are not
available for all generators; they may be omitted
depending on the intended area of application.
Important
y Under unfavorable circumstances,
condensate water may form
within the generator.
►
Multiple holes have been made
in the generator housing as
a drain for condensation water
(front and rear, each has 4 holes,
arranged at an angle of 90°).
y
Do not use the holes on both sides and on the
top side. Seal them with M4x8 screws.
y
The holes on the bottom side are used to
drain off condensation water and must not be
sealed with screws.
Note
y The holes on the rear side are covered by the fan wheel cover.
► Remove the cover to gain access to the holes.
y
Check whether the two holes on the
underside are open. If necessary, remove the
screws from the holes in order to open the
condensation water drains.
Max. thread length 8 mm