GTS BG 132, Installation And Operating Manual

Page: 104 / 128

Sy
nch
ro
no
us g
en
er
at
or
s o
f s
er
ie
s D
G
G
, D
W
G a
nd W
G
Issue 05/2013 Page 104
Disassembly
Disassembly of single-bearing generators
10.4.1 Disassembly of single-bearing brush generators
Preparatory work and removal of carbon brush holder
>
Disconnect electrical connection lines of the generator.
Ö
Installation of generator, page 28
>
Unscrew the two M8 x 45 screws, wrench size 10 mm, [2] .
>
Remove the sleeve [1] .
>
Remove both connection lines from the connecting lugs of the carbon
brush holder [5] .
The connection lines are coded by the size of the connecting lugs thus
protecting them against being swapped.
>
Unscrew the mounting screw of the carbon brush holder and remove the
carbon brush holder [5] .
Continue with the disassembly with the following descriptions
- For shaft attachment via grub screw
Ö
Disassembly of shaft attachment via the grub screw, page 105.
#- For shaft attachment via tension bolt
Ö
Disassembly of shaft attachment via tension bolt, page 107.
1
2
5
3
4
Fig. 31 Preparatory work, disassembly of single-bearing brush
generators