7.3.5
Use the rotor deblocking tool
Preliminary requirements
•
Rotor deblocking tool
•
Wrench size 10
Procedure
1. Remove the bolts (A) and the
washers (B).
2. Remove the bracket (C).
3. Remove the cover (D).
4. Move the rotor deblocking tool over
the shaft of the rotor (E).
5. Move the tool to remove the wood
chips.
7.3.6
Finish
Procedure
1. Install the cover (A).
2. Install the bracket (B).
3. Install the bolts (D) and the washers
(C).
4. Install the input. Refer to section
.
5. Install the output. Refer to section
.
Caution:
A blockage can cause
damage to the blades.
6. If the blades are damaged after a
blockage, replace them. Refer to
section
7.4
Replace a safety sign
Note:
For an overview of the location of the safety signs, refer to section
.
1. Remove and discard the damaged or worn safety sign.
2. Clean the surface.
3. Install the new safety sign.
C
B
A
E
D
B
C
D
A
Corrective maintenance
42
D09-CC13S20-11
