- 37 -
STIM 1916 CT
n
et work
Herein you customize the IP Addresses,
Gateways and Subnet Masks for the
configuration interface and the stream-
ing interface to the local network.
The configuration interface and the
streaming interface must be assigned
to different IP address ranges
(fac-
tory setting 192.168.
0
.120 and
192.168.
10
.120)!
Enter fixed IP addresses which are not
yet assigned and are out of the DHCP
range of the router.
You can use the
Hostname
to call up the
user interface without entering the IP ad-
dress. To do this, enter the
host name
followed by "
.local
" in the browser (
e.g. gss.local
). If you operate several
head-end stations in the network, you must enter different names here.
—> Write down the IP addresses and the Host name! Further access to
the device is only possible via the IP address of the configuration
interface or the host name.
—>
If you have forgotten your IP address, you can reset the network
settings and the password by the reset button
(
3
—> For remote access it is important to setup a gateway with Internet
access.
—> The MAC address is only displayed for information an can not be
changed.
—> Before leaving the menu, changes must be transferred to the head-
end station! Therefore click on button
.
—> After that
is displayed for a short time in the upper right corner.
—> The device requests the required multicast IP streams via the Stream-
ing Interface every 60 seconds.
Querier requests will not be an-
swered!
Keep this in mind when configuring the network (querier
host timeout > 60s).
