- 27 -
PHDT 1000 H
channel grid in the range of channels S21 … C69 (frequency grid 8 MHz).
The CCIR channel grid is 7 MHz in the range of the lower frequency bands
(channels C2 … S20). Therefore the frequency setting is used here. If one uses
the existing channel grid of 7 MHz in these channel ranges, this will result in
interference (overlapping) with the 8 MHz QAM signal packages, thus caus-
ing transmission problems.
For programming in these channel ranges and in the frequency ranges below
them, we recommend starting with channel S21 / 306 MHz going back in
steps of 8 MHz (see frequency table on page 47), or reducing the bandwidth of
the QAM output signal by removing stations.
Bx 4A
Freq.
OUTPUT
• Use
to select channel setting "
Channel
" or frequency setting "
Freq.
".
• Press the
button.
—> The next menu is activated.
o
utPut
Channel
/
frequenCy
on
/
off
o
utPut
Channel
In this menu you set the output channel of the channel strip. Additionally the
modulator of the channel strip can be switched off or on (page 28).
Bx 4A
C68
OUTPUT
on
• Use the
buttons to set the output channel.
o
utPut
frequenCy
In this menu you set the output frequency of the channel strip (42.0 …
860.0 MHz). Additionally the modulator of the channel strip can be switched
off or on (page 28).
Bx 4A
850.00 MHz
OUTPUT
on
