- 29 -
HMPT 1000 C
o
utPut
levels
of
the
Channel
striPs
This menu item is used to set the output levels of the modulators of the channel
strips "
A
" and "
B
" to the same value.
Bx 4A
0 dB
LEVEL
• Measure and note down the output level of the channel strip.
• By repeatedly pressing the
button scroll back to the "Selecting the
channel strip" menu.
• Select the other channel strip (page 27) and set the following menu items:
• "Selecting channel / frequency setting", page 27.
• "Setting the output channel" or "Setting the output frequency", page 28.
• Switch on the modulator if necessary, page 28.
• Measure and note down the output level.
• Activate the "
LEVEL
" menu of the channel strip with the higher output level.
• By pressing
adjust the higher output level of one channel strip to
the lower output level of the other channel strip incrementally from "
0
" to
"
–10 dB
".
• Press the
button.
—> Channel strip "
A
":
The "Selecting the input data stream" – "
INPUT
" menu is activated.
—> Channel strip "
B
":
The "Switching the IP address off or on, selecting the transmission
protocol, setting the port number" – "
MODE / PORT
" menu is acti-
vated (page 29).
i
nPut
data
strea m
In this menu you select the signal source for the selection of the services. The
transport streams to be processed are provided by the tuner of channel strip
"
A
" and the LAN interface "
Lan
".
Bx 4A
Lan
INPUT
