- 29 -
HDM 660 T
• Press the
button.
—> The "Transmitter identification" – "
COFDM TPS
" menu is activated.
t
r ansmit ter
identifiCation
(Cell id)
At terrestrial transmission an identification is referred to each COFDM modu-
lated transmitter. When COFDM modulated signals are fed into cable net-
works this identification is not necessary usually. If receiving problems should
occur you must refer a transmitter identification (CELL ID) to each output chan-
nel and switch "
on
" the transmitter identification.
Bx 1A
CELL 0x0000
COFDM TPS
off
• Use the
buttons to position the cursor under the digit of the hexadeci-
buttons to position the cursor under the digit of the hexadeci-
mal number to be set.
•
Press
to set the respective digit of the hexadecimal number.
• Repeat the procedure by the quantity of the digits to be set.
• Using the
button place the cursor under "
off
" and switch "
on
" the trans-
mitter identification using the
buttons.
—> By pressing the
button you return to the hexadecimal number
setting.
• Press the
button.
—> The "Output data rate" – "
STUFFING
" menu is activated.
o
utput
data
r ate
This menu shows the output data rate defined using the COFDM settings and
the current measured output data rate.
Bx 1A
31667
(20351)
STUFFING
Zahl 1
Zahl 2
Number 1 Number 2
31667
(= "Number 1"): Defined net output data rate
