- 11 -
HDM 660 T
4
t
he
Control
panel
at
a
glanCe
4.1 m
enu
items
Program the COFDM module using the buttons on the head-end station control
panel. The menus appear on the two-line display of the control panel.
The parameters and functions to be set are underlined.
With the button select the channel strip / other modules.
You can use the button to select the following menu items:
– Activating the module and channel strip
– Channel setting / frequency setting
– Output channel / output frequency
– Output level
– LNB oscillator frequency
– Input symbol rate
– Input frequency
– Station filter
– CA module (if available)
– Output signal
– Transmission parameters
– Station identification
– Stuffing
– Substitute signal
– Transport stream and ORGNET-ID
– Network Information Table (NIT)
– Deleting a PID
– Renaming a PID
– Factory Reset
– Save data
4.2 f
unCtions
of
the
Control
panel
but tons
S
M
To move the cursor, call up
functions
To adjust values and functions
To save the programmed data
To switch to the next menu
