- 6 -
HDE 166
The module is equipped with four video/stereo audio inputs. The fed in ana-
logues signals are digitized and supplied to an encoder that encodes them in
real time. The stereo audio signals are transferred via an adjustable amplifier
to the encoder.
At the Ethernet socket (RJ45) up to four SPTS transport streams or one MPTS
transport stream (Multi Programme Transportstreams) according to UDP or RTP
protocol is output.
When the head-end station is switched on, the two-line LC display shows the
"
SETUP
" menu and the software version of the control unit.
To operate the encoder module the software version of the control unit (head-
end station) must be "
V 10
" or higher. The operating software of the encoder
module and the head-end station can be updated using a PC and the software
"
BE-Flash
" via the 9-pin D-SUB socket on the head-end station. You can find
the current operating software for the head-end station and the encoder mod-
ule, the software "
BE-Flash
" and the current assembly instructions on the web-
site "
www.mygss.eu
".
The encoder module is designed exclusively for use in the STC 160 head-end
station.
3
i
nstallation
– Ensure the head-end station is mounted so it will not be able to vibrate.
Avoid, for example, mounting the head-end station onto a lift shaft or any
other wall or floor construction that vibrates in a similar way.
– Before installing or changing a module, switch off the head-end station or
unplug the power cable from the mains power socket.
– Take measures to protect against ESD!
• Open the housing of the head-end station in accordance with the assembly
instructions for the STC 160.
