GSi Smart Climate 310, User Manual

Page: 80 / 102

80 Smart Climate 310 rev. 03
ALARMS
The alarm output is activated when certain alarm conditions are
detected.
For example, when the room temperature is too high or too low, an
alarm is set off. Each new alarm type is recorded until it is
acknowledged
. The alarm conditions are as follows:
•
Defective probe
• Defective potentiometer
• Temperature alarm
•
Water spill alarm
•
Communication alarm with the auxiliary module
• Loss of power to the controller
Alarm Log
After having been corrected, all alarm conditions must be
acknowledged by the user. All alarm conditions are kept in the
alarm memory of the controller until they are acknowledged. The
controller identifies alarm conditions as follows:
Active alarm:
The alarm condition is active. The alarm output is active and the
corresponding alarm pilot light is lit. A corrective action is required.
Unacknowledged alarm:
The alarm condition no longer exists but needs to be
acknowledged by the user. The alarm output is disabled, the alarm
pilot light is off, and the alarm condition is kept in the alarm
memory.