GSi Smart Climate 310, User Manual

Page: 41 / 102

Smart Climate 310 rev. 03 41
Adjusting the Minimum Speed of Variable Outputs
You must specify the initial speed of each variable output for each
variable fan stage. It ranges from 10% to 100%.
NOTE:
The first fan stage performed by the controller is the
variable stage assigned for minimum ventilation, which is not
necessarily stage 1
NOTE: The number of stages displayed in the following menu is
limited by the maximum fan stage selected at the beginning of
this section.
To adjust the minimum speed, proceed as follows:
1. Press Stages .
2. Press the down-arrow key in order to select the speed of
the first variable output of the first variable fan stage. (The
number displayed on screen refers to the stage number).
Only the variable outputs using the "Variable" operating mode are
displayed.
3. Press Adjust twice and then use the arrow keys to set the
initial speed to the desired value.
4. Press the down-arrow key to select the second variable
output (if applicable).
5. Repeat steps 1 to 4 to set the speed of each variable
output for all variable fan stages.