GSi Smart Climate 310, User Manual

Page: 13 / 102

Smart Climate 310 rev. 03 13
INSTALLATION
Mounting the Enclosure
1. Open the latch and lift the cover.
2. Remove the black caps located on each of the four
mounting holes.
3. Mount the enclosure on the wall using four screws.
Be sure the electrical knockouts are at the bottom of the enclosure in
order to prevent water from entering the controller.
4. Insert the screws in the mounting holes and tighten.
5. Fasten the four black caps provided with the controller
onto the four mounting holes. The enclosure must be
mounted in a location that will allow the cover to be
completely opened right up against the wall.
Identifying Defective Probes
An alarm is generated when a defective probe is detected. To
identify the defective probe, proceed as follows:
1. Press the Current Conditions button.
2. Press on the current conditions down-arrow key.
Probe readings are displayed. Dashes are displayed instead of a
reading when the probe is defective. In the case of room
temperature probes, the controller will operate according to the
temperature of the remaining probes.
Connecting Alarms Wires
There are two types of alarms:
• If the alarm activates when
current is cut off at the input,
use the NC (normally closed)
terminal for wiring.
• If the alarm activates when
current is supplied at the input,
use the NO (normally open) terminal for wiring.